| |
Care & Maintenance of Powder Coated and Anodised Surfaces:
To realise the full potential from powder coated and anodised aluminium, ongoing maintenance procedures should be followed. The effects of ultra violet light, atmospheric pollution, general dirt and grime and airborne salt deposits can all accumulate over time, and for this reason, accumulated deposits must be removed at regular intervals. As a general rule, powder coated surfaces should be cleaned every six months. In areas where pollutants are more prevalent, or in exposed coastal areas, (e.g., industrial, geothermal areas and beach-front houses) a more frequent cleaning programme should be carried out, e.g., every three months.
When cleaning, use dilute solution of mild, neutral liquid detergent, e.g., dish washing detergent, and warm water (400 C) and a soft, lint free cloth or brush. Do not use abrasive cleaning tools such as steel wool, hard brushes, abrasive scourers, etc., as these may damage the coating surface, and change the colour or gloss levels of the finish. Rinse suds off thoroughly with fresh water, and dry with a clean cloth.
It is vital that any other chemicals such as petrol, strong alkalines or acids are NOT used on any powder coated surface.
Touch-up: (for powder coated surfaces only)
Aerosol and dab stick applicators for unintentional chips or dents are available from Orica Powder Coatings in most stock colours. It is recommended however that the use of these products be restricted to minor areas and only for cosmetic improvement.
|
